With new process technology, material and lithography techniques, new designs can no longer be analyzed statically. While design for manufacturing (DFM) helped narrow the bridge between design and process, real in-circuit measurements are more and more critical to understanding the margins required to ensure good and predictable yields.
Presto Engineering's core technology and expertise come from integrating test (ATE) and physical fault isolation capabilities in order to provide dynamic analysis of new designs and other devices.
Such combination brings unique electrical failure isolation techniques to the process of qualifying new designs and releasing new products. It also provides unique insight into new process development and process transfers.
Our combined 60+ years of expertise in integrating test and analysis (from a mechanical, thermal, electrical and timing standpoint) gives our customers access to data, information and knowledge about their designs that only very few IDMs can afford today.
Supported capabilities:
Once a physical location has been identified (PFI) and confirmed (EFA), failure analysisis performed in order to exhibit the physical cause of the defect.
Finally, root cause analysis can be performed in collaboration with design or process engineers, in order to establish corrective action plans, preventing the exhibited defects to re-occur.
We use a network of qualified partners to provide a one-stop solution for all design success analysis needs. Our engagements are fixed-cost, deliverables-based projects that garantee results.
Please call us at 408-434-1808 x303 or contact us and schedule a discovery meeting to understand how Presto Engineering will provide you with the value of state-of-the-art test and failure analysis—at a cost your business can afford.
